DAVIES CRAIG DIGITAL THERMATIC FAN SWITCH KIT DC0444
Davies Craigs Digital Thermatic Fan Switch Kit can be used with Davies Craig Thermatic Fans, EWP's and competitors Fans. It senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section or the sensor can now also be placed directly into the coolant system in combination with a Temperature Sensor Adaptor Kit (Part 0409). It can be used for 12 or 24 volt applications and has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF) which can show Centigrade or Fahrenheit. Temp is set by pressing the set button. It can run 1 or 2 fans. The second fan (if applicable) will start 10 seconds after Fan #1 runs. It operated thermally & also when the air conditioning is in operation.
Digital Fan Controller x 1
Mount Kit x 1
Scotch Lock x 1
Ring Terminal (yellow) x 1
Self Tap Screw x 2
Connector (yellow) x 1
Davies, Craig Pty Ltd very own designed Digital Thermatic Fan Switch Kit can be used with our Thermatic Fans, EWP's & competitors Fans.
Simply set the temperature by pressing the set button.
It can run 1 or two fans. The second fan (if applicable) will start 10 seconds after Fan #1 runs. The fans will operate until the air temperature is reduced by 5 degrees (C) from the set temperature.
• Probe connection 900mm long
• Suitable for both 12v & 24v electrical systems
• Adjustable temperature setting button, a simple change from Centigrade to Fahrenheit
• Increase to 5°c for fan shut down
• Increase to 10 secs. for second fan engagement
*Note: Kit sold in 12 volt configuration, for 24 volt application, you will need to change the two relays with 24 volt units which are not supplied in the kit.
AIR TEMPRETURE APPLICATION:
It senses air temperature as it passes through the radiator and has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF).
The Temperature Sensor is placed in the radiator fin section as close to the hot coolant inlet as possible, no need to cut hoses or can be placed directly into the coolant system.
WATER / COOLANT APPLICATION:
The DC0444 sensor can now also be placed directly into the coolant system. To help you identify if your DC0444 is capable of water / coolant applications, the sensor cable will be 1meter in length whilst the older DC0444 units only have a 50cm cable.
Max voltage: 15V
Max curren 50A
Relay setup: Dual relay
Speed: Single speed - 10 sec. delay to start up the second fan
Applications: Suitable for single and dual fan applications
Temperature Display: LED digital temp display – actual temp + set temp
Temp Display: Centigrade+ Fahrenheit
Temp settings: 40°c to 110°c (104°F to 230°F)
Temp setting: Push Button
Circuit type: Pre-programmed micro controller
Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe
Dimensions: 95x65x56 mm
Quantity: Sold as a kit
Note: if using this switch for use with our EWP's, it will not vary the speed of the pump in response to engine temperature but rather turn the pump on and off at your set temperature. For EWP control, we would recommend part number 8020 which can manage both the EWP and your Thermatic Fans.
Items will be shipped within one to five business days after full payment has been received, the duration of dispatch
depends on which of our warehouses the item located at.
|Unit Of Measure||ea|
Be The First To Review This Product!
Help other Engine Master Australia users shop smarter by writing reviews for products you have purchased.